IPFIX on Extreme Networks switch

I am trying to configure IPFIX on an Extreme Networks x460 but receiving the following error in NTA:

NetFlow Receiver Service [servername] received an invalid IPFIX template with ID 265 from device

After looking at the data being sent to the collector I seem to be missing both the INPUT_SNMP and OUTPUT_SNMP information, (presuming this is the issue, please correct me if I am wrong) how do you configure the switch to provide the missing data?

current IPFIX config:

configure ip-fix ip-address xxx.xxx.xxx.xxx protocol udp L4-port 2055 vr "VR-Default"

configure ip-fix source ip-address xxx.xxx.xxx.xxx vr "VR-Default"

configure ip-fix ports 47 ingress-and-egress

enable ip-fix ports 47 ipv4

configure ip-fix ports 48 ingress-and-egress

enable ip-fix ports 48 ipv4

Show ip-fix

Global IPFIX State: Enabled
Domain:             0
Source (Exporter) IP:   xxx.xxx.xxx.xxx      Virtual Router:         "VR-Default"
Collector IP:           xxx.xxx.xxx.xxx
Transport Protocol/Port/State:  UDP, Port 2055, NA

Flow Keys:
IPv4:   "Source-IP"  "Source L4 Port"  "Dest-IP"  "Dest L4 Port"  "L4 Protocol"  "TOS"
Unused:

IPv6:   "Source-IP"  "Source L4 Port"  "Dest-IP"  "Dest L4 Port"  "Next Header"  "TOS"  "Flow Label"
Unused:

Non-IP: "Source MAC"  "Dest MAC"  "Ethertype"  "VLAN ID"  "Priority"  "Tagged"
Unused:

IPFIX Enabled on Port(s):    47-48

Any help/recommendations much appreciated!

Thanks