Hi All,
Cisco 2602 Access Point:
Currently running cat tool 3.9.1 and backup over 700+ devices with all makes and models. With Cisco bringing out their new line of APs backing them up seems to be proving a little painful. When the running config backup runs, its marked as successful and no errors except the txt file of the backup reveals:
^
% Invalid input detected at '^' marker.
Pretty interesting, I understand that 3.10 has just been released, I'm not keen just jumping a new version so close to release so curious if anyone has seen this one before?
Secondly,
Dell I/O Aggregator:
This bit of kit is new too me but seems to run your Dell CLI so I am able to ssh into the device and begin the backup, however it gets to the first --More-- then ends the session and saves it as that:
Current Configuration ...
! Version 8.3.17.4
! Last configuration change at Mon May 5 11:53:42 2014 by root
!
boot system stack-unit 0 primary system: A:
boot system stack-unit 0 secondary system: B:
boot system stack-unit 0 default system: B:
!
redundancy auto-synchronize full
!
no logging console
service timestamps log datetime localtime
!
hostname AHGBLADE01-IOA1
!
!
bsd-username network_backup secret **********************************************************
username network_backup secret 5 ************************ privilege 15
username root password 7 ***************************
mac-address-table aging-time 300
!
stack-unit 0 provision I/O-Aggregator
!
--More-- (a whole bunch of arrows here)
And thats it, can't seem to find much out there, so besides the software update to see if its a supporting issue I cant seem to figure this one out. Anybody else running these that can offer some advice.
Cheers,
Andrew - Perth.